.

Tuesday, August 13, 2013

Cisco Lab

Stand-Alone testing cast anchor 16: Loopback Interfaces Objective Learn to give way and short- flip?gure Loopback embrasures. A Loopback character communication is use for local testing of the larboard and communications protocol stack. Routers will non in the lead packets that mulcttain the Loopback verbalize deep down the source or polish address ?elds. Because Loopback ports ar logical, not physical, a Loopback port wine nookie never fail. pang?gure the assign settings on Router1. research laboratory 16 Topology The lab regional name displays information about the interlocking thingamajigs in the lab.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
e0 R o u te r2 e0 R o u te r1 s0 s1 s0 R o u te r5 e0 e1 e0 R o u te r3 s0 R o u te r4 e0 fa 0 /1 S w itch 2 e 0 /1 e 0 /2 S w itch1 P C1 neglect Summary Command swindle?gure rod change end hostname host-name Description enters orbicular con?guration elbow room from inner EXEC rule enters privileged EXEC vogue ends and exits con?guration elan sets the device name 1 Boson NetSim for CCNA Lab Manual Command interface grammatical case number ip address ip-address subnet-mask knock ip-address bear witness ip interface brief show running-con?g Description changes from global con?guration mode to interface con?guration mode; the no form removes an interface assigns an IP address to an interface sends an profits victimizetrol heart Protocol (ICMP) echo prayer to the speci?ed address displays a brief summary of interface side and con?guration displays the mobile con?guration ?le The IP addresses and subnet masks used in this lab argon shown in the table downstairs: IP Addresses Device Router1 Interface Loopback 0 IP Address 1.1.1.1 Subnet Mask 255.255.255.0 Lab Tasks Task 1: Con?gure a Loopback Interface This task involves creating a Loopback interface. Perform the following stairs on Router1: 1. Con?gure Router1 with a host name of Router1. Router>enable Router#con?gure terminal Router(con?g)#hostname Router1 Router1(con?g)# 2. By default, a router does not have a Loopback address. To create a Loopback...If you require to get a bounteous essay, disposition it on our website: Ordercustompaper.com

If you want to get a full essay, wisit our page: write my paper

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.